DIN EN 846-14-2012 砖石工程辅助元部件试验方法.第14部分:复合材料过梁和砖石上面预制构件间初始剪切强度的测定
时间:2024-05-25 20:55:21 来源: 标准资料网 作者：标准资料网 阅读：8534
【英文标准名称】:Methodsoftestforancillarycomponentsformasonry-Part14:Determinationoftheinitialshearstrengthbetweentheprefabricatedpartofacompositelintelandthemasonryaboveit;GermanversionEN846-14:2012
【原文标准名称】:砖石工程辅助元部件试验方法.第14部分:复合材料过梁和砖石上面预制构件间初始剪切强度的测定
【标准号】:DINEN846-14-2012
【标准状态】:现行
【国别】:德国
【发布日期】:2012-11
【实施或试行日期】:
【发布单位】:德国标准化学会(DE-DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:粘着剪切强度;砖;组件;建筑;施工材料;定义;门窗过梁;砖石工程;砌石墙;材料测试机;灰浆;预制的;剪切强度;材料强度;试验报告;试验
【英文主题词】:Adhesiveshearstrength;Bricks;Components;Construction;Constructionmaterials;Definitions;Lintels;Masonry;Masonrywalls;Materialtestingmachines;Mortars;Prefabricated;Shearstrength;Strengthofmaterials;Testreports;Testing
【摘要】:
【中国标准分类号】:
【国际标准分类号】:91_080_30
【页数】:18P;A4
【正文语种】:德语
MIL-C-89303, MILITARY STANDARD: CITY GRAPHICS (30 NOV 1990) [SUPERSEDES PS/3CB/301]., This specification defines requirements for the Defense Mapping Agency's (DMA) City Graphics.Product Code:SAE J551/4
Title:Test Limits and Methods of Measurement of Radio Disturbance Characteristics of Vehicles and Devices, Broadband and Narrowband, 150 kHz to 1000 MHz (Cancelled Sep 2006)
Issuing Committee:Electromagnetic Compatibility (Emc) Standards
Scope: This SAE Standard contains test limits and procedures for the measurement of radio disturbances in the frequency range of 150 kHz to 1000 MHz. The document applies to any electronic/electrical component intended for use in vehicles. Refer to International Telecommunications Union (ITU) Publications for details of frequency allocations. The test limits are intended to provide protection for receivers installed in a vehicle from disturbances produced by components/ modules in the same vehicle. The receiver types to be protected are: broadcast radio and TV, land-mobile radio, radio telephone, amateur and citizens' radio. The limits in this document are recommended and subject to modification as agreed between the vehicle manufacturer and the component supplier. This document shall also be applied by manufacturers and suppliers of components and equipment which are to be added and connected to the vehicle harness or to an on-board power connector after delivery of the vehicle. This document does not include protection of electronic control systems from RF emissions, or from transient or pulse type voltage fluctuations. These subjects are covered in other sections of SAE J551 and in SAE J1113.